OPGW Cable Guy Grips 120KN
The Formed Wire Dead-End uses two helically shaped formed wire components: an inner layer of structural reinforcing rods and an outer-layer dead-end component to distribute axial and compressive loads over the applied area of the OPGW.
Products Description
The Formed Wire Dead-End uses two helically shaped formed wire components: an inner layer of structural reinforcing rods and an outer-layer dead-end component to distribute axial and compressive loads over the applied area of the OPGW. The distribution of these loads reduces stresses on the central core and optical fibers of the OPGW.
A full set of the tension set include dead end component, structural reinforcing rods and the matched fittings.
The grip strength of this clamp is bigger than 95% of the rated tensile strength.
This kind of clamp have simple structure, easy to installation and also enables to reduce the cost.
Product application
Formed Wire Deadend for 14.2-18.4mm OPGW .
Tensile Strength : 120KN
Product selection
Hot Tags: opgw cable guy grips 120kn, China opgw cable guy grips 120kn manufacturers, suppliers, factory, preformed dead end cable grips, guygrip, OPGW Cable Guy Grips 70KN, guy wire preform, dead end grips, guy wire dead end grips
Send Inquiry
